Fuji Electric FRENIC-Ace series, User Manual

Page: 525 / 788

9.1 Overview of RS-485 Communication
9-1
CO
M
M
U
NI
C
AT
IO
N
FUN
CT
IO
N
S
Chap 9
9.1 Overview of RS-485 Communication
The FRENIC-Ace has two RS-485 communication ports at the locations shown below.
(i)
Communication port 1: RJ-45 connector for the keypad (modular jack)
(ii) Communication port 2:
RJ-45 connector for RS-485 communication (modular jack) * only for type FRN-E2
■
-2/4/7GA, -2/4/7J;
RS-485 terminals (control circuit terminals SD, DX-, DX+) * only for FRN-E2
■
-2/4/7GB, -4C
COM port 1 COM port 2
Using the RS-485 communication ports shown above enables the extended functions listed below.
• Remote operation from a keypad at the remote location (COM port 1)
The standard keypad enables remote operation by mounting the keypad on a remote panel and connecting the
keypad to RJ-45 connector with an extension cable. (maximum cable length: 20 m)
• Operation by FRENIC Loader (COM ports 1 and 2)
It is possible to edit and monitor the function codes by connecting the RJ-45 connector (RS-485 communication)
in the inverter and PC and using the inverter support loader (FRENIC Loader, see “9.3 FRENIC Loader
Overview”).
• Control via host equipment (COM ports 1 and 2)
Connecting the inverter to the host equipment (upper controller), such as a computer and programmable
controller (PLC), enables to control the inverter as a subordinate device.
Besides the communication port 1 (RJ-45 connector) shared with the keypad, the FRENIC-Ace has the RS-485
communication port 2 by default.
The protocols for controlling inverters support the Modbus RTU protocol (compliant to the protocol established
by Modicon Inc.) that is widely used and the Fuji Electric’s general-purpose inverter protocol that is common to
Fuji Electric’s inverters including conventional series.
• Connecting the keypad to the COM port 1 automatically switches to the keypad protocol; there is no
need to modify the function code setting.
• When using FRENIC Loader, which requires a special protocol for handling Loader commands, you
need to set up some communication function codes accordingly.
For details, refer to the FRENIC Loader Instruction Manual.

For details of RS-485 communication, refer to the RS-485 Communication User’s Manual.
RJ-45
connector
RJ-45
connector
RS-485 terminals (SD, DX-, and DX+)
(which facilitate multi-drop connection.)