Fuji Electric FRENIC-Ace series, User Manual

Page: 112 / 788

3.4 Programming Mode
3-18
Basic key operation
(1) Turn the inverter ON. It automatically enters Running mode in which you press the key to switch to
Programming mode. The function selection menu appears.
(2) Use the and keys to select the desired function code group from the choices
!f__
through
!k__
.
(3) Press the key to proceed to the list of function codes for the selected function code group.
(4) Use the and keys to display the desired function code, then press the key.
The data of this function code appears.
(5) Change the function code data using the and keys.
(6) Press the
key to establish the function code data.
The
saue
appears (blinking) and the data will be saved in the memory inside the inverter. After that, the
display will return to the function code list and then move to the next function code.
Pressing the key instead of the key cancels the change made to the data. The data reverts to the
previous value, the display returns to the function code list, and the original function code reappears.
(7) Press the key to return to the menu from the function code list.
Cursor movement
When changing function code data, pressing the key once blinks the least significant digit. After that,
each time the key is pressed, the cursor moves to the next higher digit where data can be changed.
This cursor movement allows you to easily move the cursor to the desired digit and change the data in
higher digits.
3.4.2 Checking changed function codes “Data Checking:
"rep
”
Menu #2 “Data Checking” (
"rep
) in Programming mode allows you to check function codes that have been
changed. Only the function codes whose data has been changed from the factory defaults are displayed on the LED
monitor. You can refer to the function code data and change it again if necessary.
To check function codes in Menu #2 “Data Checking,” you need to set function code E52 to “1” (Function code data
check mode) or “2” (Full-menu mode).
The menu transition in “Data Checking” is the same as the one in Menu #1 “Data Setting.”