Fuji Electric FRENIC-Ace series, User Manual

Page: 128 / 788

3.4 Programming Mode
3-34
3.4.7 Copying data “Data Copying:
'cpy
”
The data copy function can only be used when the keypad with USB (option: TP-E1U) is connected. Menu #7 “Data
Copying” is used to read function code data out of an inverter for storing it in the keypad or writing it into another
inverter. It is also used to verify the function code data stored in the keypad with the one configured in the inverter.
The keypad serves as a temporary storage media.
In addition, using Menu #7 allows you to store the running status information in the keypad, detach the keypad from
the inverter, connect it to a PC running FRENIC Loader at an office or off-site place, and check the inverter running
status without removing the inverter itself.
To store the inverter running status information into the keypad, use “Read data” (read ) or “Read inverter running
information” (chec ) function. For details on how to connect the keypad to a PC and check the inverter running status
information stored in the keypad, refer to the FRENIC Loader Instruction Manual.
Figure 3.4-5 shows the menu transition in Menu #7 “Data Copying.” The keypad can hold function code data for a
single inverter.
Figure 3.4-5 Menu Transition in Menu #7 “Data Copying”