Fuji Electric FRENIC-Ace series, User Manual

Page: 190 / 788

5.2 Function Codes Table
5-20
Code Name Data setting range
C
han
ge
w
hen
ru
nn
ing
D
at
a
co
py
in
g
Factory
Default
Drive control
R
el
at
ed
p
ag
e
V
/f
PG
V/
f
w
/ P
G
Tor
qu
e c
on
tro
l
PM
H154 Torque bias (Mode selection)
*5
0: Invalid
1: Digital torque bias
2: Analog torque bias
N Y 0 N N Y N N 5-190
H155 (Level 1) -300 to +300 % N Y 0 N N Y N N
H156 (Level 2) -300 to +300 % N Y 0 N N Y N N
H157 (Level 3) -300 to +300 % N Y 0 N N Y N N
H158 (Mechanical loss
compensation)
0 to 300 % N Y 0 N N Y N N
H159 (Startup timer) 0.00 to 1.00 s N Y 0.00 N N Y N N
H161 (Shutdown timer) 0.00 to 1.00 s N Y 0.00 N N Y N N
H162 (Limiter) 0 to 300 % N Y 200 N N Y N N
H173 Magnetic flux level at light load
*5
10 to 100 % Y Y 100 N N Y Y N 5-192
H180 Brake control signal
(Check-timer for brake
operation)
0.00 to 10.00 s Y Y 0.00 Y Y Y N N 5-192
H193 User initial value (Save) 0: Disable, 1: Save Y N 0 Y Y Y Y Y 5-156
H194 (Protection) 0: Save enable,
1: Protected (Save disable)
Y Y 0 Y Y Y Y Y
H195 DC braking
(Braking timer at the startup)
0.00 (Disable): 0.01 to 30.00 s Y Y 0.00 Y Y N N N 5-74
5-192
H196 Reserved *5 *9 0.001 to 9.999, 999 Y Y 999 Y Y N N N –
H197 User password 1
(Selection of protective
operation)
0: All function codes are disclosed, but the change is not
allowed.
1: Only the function code for quick setup can be
disclosed/changed.
2: Only the function code for customize logic setting is not
disclosed/not changed.
Y Y 0 Y Y Y Y Y 5-187
H198 (Setting/check) 0000 to FFFF (Hexadecimal) Y N 0 Y Y Y Y Y
H199 User password protection
valid
0: Disable
1: Protected
Y N 0 Y Y Y Y Y
*5: Available at ROM version 0300 or later.
*9: Factory use. Do not access these function codes.