Digi TX54, User Manual

Page: 123 / 1087

Interfaces Wide Area Networks (WANs)
TX54 User Guide 123
---------------------------------------------------------------------
----------
dhcp_hostname false DHCP Hostname
enable true Enable
metric 0 Metric
mgmt 0 Management priority
mtu 1500 MTU
type dhcpv6 Type
use_dns always Use DNS
weight 10 Weight
Additional Configuration
---------------------------------------------------------------------
----------
connection_monitor Active recovery
(config network interface my_wan)>
d. Modify any of the remaining default settings as appropriate. For example, to change the
metric:
(config network interface my_wan)> ipv6 metric 1
(config network interface my_wan)>
If the minimum length is not available, then a longer prefix will be used.
See Configure WAN/WWAN priority and default route metrics for further information about
metrics.
8. (Optional) To configure 802.1x port based network access control:
Note The TX54 can function as an 802.1x authenticator; it does not function as an 802.1x
supplicant.
a. Enable the 802.1x authenticator on the TX54 device:
(config network interface my_wan)> 802_1x authentication enable true
(config network interface my_wan)>
b. Set the IP address of the authentication server:
(config network interface my_wan)> 802_1x authentication ip IPv4_
address
(config network interface my_wan)>
c. Set the password for the authentication server:
(config network interface my_wan)> 802_1x authentication password
password
(config network interface my_wan)>