Digi TX54, User Manual

Page: 242 / 1087

Wi-Fi Configure an open Wi-Fi access point
TX54 User Guide 242

Command line
1. Log into the TX54 command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu . Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Set transmit power for the radio:
a. Determine available radios:
(config)> network wifi radio ?
Additional Configuration
----------------------------------------------------------------------
---------
wifi1
Wi-Fi1 radio
wifi2 Wi-Fi2 radio
(config)> network wifi radio
b. Set the transmit power percentage for the appropriate radio:
(config)> network wifi radio wifi1 tx_power value
(config)>
where value is any integer between 1 and 100 and represents the percentage of transmit
power that the Wi-Fi module should use.
4. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
5. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu . Type quit to disconnect from the device.
Configure an open Wi-Fi access point
This procedure configures a Wi-Fi access point that does not require a password for client
connections.
By default, the TX54 device comes with either one or two preconfigured access points:
n
Single-Wi-Fi models: Digi AP (Wi-Fi) .
n
Dual-Wi-Fi models: Digi AP (Wi-Fi) and Digi AP (Wi-Fi2) .
You cannot delete default access points, but you can modify them or you can create your own access
points.