Digi TX54, User Manual

Page: 179 / 1087

Interfaces Local Area Networks (LANs)
TX54 User Guide 179
1. Log into the TX54 WebUI as a user with Admin access.
2. On the main menu, click Status
3. Under Networking , click DHCP Leases .

Command line
1. Log into the TX54 command line as a user with Admin access.
Depending on your device configuration, you may be presented with an Access selection
menu . Type admin to access the Admin CLI.
2. Enter the show dhcp-lease command at the Admn CLI prompt:
> show dhcp-lease
IP Address Hostname Expires
------------- --------------- -------
192.168.2.194 MTK-ENG-USER1
192.168.2.195 MTK-ENG-USER2
>
3. Additional information can be returned by using the show dhcp-lease verbose command:
> show dhcp-lease verbose
IP Address Hostname Expires Type Active
MAC Address
------------- -------- ------------------------ ------- ------
-----------------
192.168.2.194 MTK-ENG-USER1 May 19 08:25:11 UTC 2021 Dynamic Yes
ba:ba:2c:13:8c:71
192.168.2.195 MTK-ENG-USER2 May 20 11:32:12 UTC 2021 Dynamic Yes
09:eb:10:f0:bc:16
>
4. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu . Type quit to disconnect from the device.
Create a Virtual LAN (VLAN) route
Virtual LANs (VLANs) allow splitting a single physical LAN into separate Virtual LANs. This is useful for
security reasons, and also helps to reduce broadcast traffic on the LAN.
Required configuration items
n
Device to be assigned to the VLAN.
n
The VLAN ID. The TCP header uses the VLAN ID to identify the destination VLAN for the packet.