Digi TX54, User Manual

Page: 249 / 1087

Wi-Fi Configure a Wi-Fi access point with personal security
TX54 User Guide 249
2. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
3. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu . Type quit to disconnect from the device.
Configure a Wi-Fi access point with personal security
The WPA and WPA2 personal security modes allow a Wi-Fi access point to authenticate clients by
using a preshared key that the client enters when connecting to the access point.
By default, the TX54 device comes with either one or two preconfigured access points:
n
Single-Wi-Fi models: Digi AP (Wi-Fi) .
n
Dual-Wi-Fi models: Digi AP (Wi-Fi) and Digi AP (Wi-Fi2) .
You cannot delete default access points, but you can modify them or you can create your own access
points.
Required configuration items
n
Enable the Wi-Fi access point
n
Select a Wi-Fi radio for the access point (dual Wi-Fi models only).
n The Service Set Identifier (SSID) for the access point.
n
Configure security for the access point to use personal security.
n
The password (preshared key) that clients will used to connect to the access point.
n
LAN/bridge assignment. Once you configure a Wi-Fi access point, you must assign the Wi-Fi
access point to a LAN interface or to a bridge. See
Configure a LAN and Configure a bridge for
more information.
Additional configuration items
n
Determine whether to broadcast the access point's SSID.
n
Determine whether to isolate clients connected to this access point, so that they cannot
communicate with each other.
n
The amount of time to wait before changing the group key.
To configure a Wi-Fi access point to use personal security:

WebUI