Digi TX54, User Manual

Page: 383 / 1087

Routing Virtual Router Redundancy Protocol (VRRP)
TX54 User Guide 383
more often than the default of 15 minutes.
Allowed values are any number of weeks, days, hours, minutes, or seconds, and take
the format
number { w|d|h|m|s }. For example, to set Interval to five seconds, enter 5s .
iv. Click to expand Test targets > Test target .
v. Configure the test target. For example, to configure SureLink to verify internet
connectivity on the LAN by pinging my.devicecloud.com:
i. For Test Type , select Ping test .
ii. For Ping host , type my.devicecloud.com .
11. Click Apply to save the configuration and apply the change.

Command line
1. Log into the TX54 command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu . Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Create a new VRRP instance, or edit an existing one. See Configure VRRP for information about
creating a new VRRP instance.
4. Enable VRRP+:
(config)> network vrrp VRRP_test vrrp_plus enable true
(config)>
5. Add interfaces to monitor. Generally, this will be a cellular or WAN interface.
a. Use the ? to determine available interfaces:
(config)> network vrrp test interface ?
Interface: The network interface.