Digi TX54, User Manual

Page: 305 / 1087

Hotspot Hotspot configuration
TX54 User Guide 305
3. Click Apply to save the configuration and apply the change.

Command line
1. Create a new routing policy. See Configure a routing policy for instructions.
2. During configuration, set the source address type to zone :
(config network route policy 0)> src type zone
(config network route policy 0)>
3. Set the zone to hotspot :
(config network route policy 0)> src zone hotspot
(config network route policy 0)>
4. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
5. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu . Type quit to disconnect from the device.
Create a new hotspot
Required configuration items
n
A device or bridge for the hotstpot.
l
If a bridge is used, it must be included in an interface with an assigned IP address.
n
The authentication mode:
l
If Local shared password is selected for the authentication mode, include the password.
l
If RADIUS shared password or RADIUS users is selected for the authentication mode,
include RADIUS configuration information.
l
If HotspotSystem is selected for the authentication mode, include HotspotSystem
configuration information.
See Hotspot authentication modes for more information about authentication modes.
n
The login page source, either Local or Remote .
l
If Remote is selected, include the IP address of fully-qualified domain name of the remote
web server that serves the login page.
n
An IP address and subnet for the hotspot.