Digi TX54, User Manual

Page: 601 / 1087

Services Location information
TX54 User Guide 601
n
To add a message type:
a. For Add NMEA filter or Add TAIP filter , click

.
b. Select the filter type. Allowed values are:
l
AL : Reports altitude and vertical velocity.
l
CP : Compact position: reports time, latitude, and longitude.
l
ID : Reports the vehicle ID.
l
LN : Long navigation: reports the latitude, longitude, and altitude, the horizontal
and vertical speed, and heading.
l
PV : Position/velocity: reports the latitude, longitude, and heading.
12. For Outgoing message type , select either NMEA or TAIP for the type of message that the
device will forward to a remote host.
n (Optional) If NMEA is selected, select a Talker ID .
The talker ID is a two-character prefix in the NMEA message that identifies the source
type. The talker ID set here will override the talker ID from all sources, and all
forwarded sentences will use the configured ID. The default setting is
Default , which
means that the talker ID provided by the source will be used.
13. (Optional) For Prepend text , enter text to prepend to the forwarded message. Two variables
can be included in the prepended text:
n
%s : Includes the TX54 device's serial number in the prepended text.
n %v : Includes the vehicle ID in the prepended text.
For example, to include both the device's serial number and vehicle ID in the prepend
message, you can enter the following in the
Prepend field:
__|%s|__|%v|__
14. Type a four-digit alphanumeric Vehicle ID that will be included with to location messages. If
no vehicle ID is configured, this setting defaults to 0000.
15. Click Apply to save the configuration and apply the change.

Command line
1. Log into the TX54 command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu . Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>