Digi TX54, User Manual

Page: 247 / 1087

Wi-Fi Configure an open Wi-Fi access point
TX54 User Guide 247
3. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu . Type quit to disconnect from the device.
Edit an existing Access point
1. Log into the TX54 command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu . Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Show available access points:
(config)> network wifi ap ?
Additional Configuration
------------------------------------------------------------------------
-------
digi_ap1 Digi AP (Wi-Fi1)
digi_ap2 Digi AP (Wi-Fi2)
(config)>
4. Set the SSID for the appropriate access point:
(config)> network wifi ap digi_ap1 ssid my_SSID
(config)>
5. SSID broadcasting is enabled by default for the preconfigured access points. If SSID
broadcasting is disabled:
(config)> network wifi ap digi_ap1 ssid_broadcast true
(config)>
6. Set the security for the access point to an open security method:
(config network wifi ap new_AP)> encryption type value
(config network wifi ap new_AP)>
where value is either:
n
none : No encryption is used.
n
owe : Uses WPA3 Enhanced Open, which uses Opportunistic Wireless Encryption (OWE)
technology to provide encryption for Wi-Fi networks that do not use password
protection.
Note Only select owe if you know that all Wi-Fi clients connecting to this device will
have WPA3 capabilities.