Digi TX54, User Manual

Page: 971 / 1087

Diagnostics View system and event logs
TX54 User Guide 971
2. Use the show event command at the Admin CLI prompt:
> show event
Timestamp Type Category Message
---------------- ------- --------- --------------------------------------
-----
Nov 26 21:42:37
status stat
intf=eth1~type=ethernet~rx=11332435~tx=5038762
Nov 26 21:42:35
status system local_time=Thu, 08 Aug 2019 21:42:35
+0000~uptime=3 hours, 0 minutes, 48 seconds
...
>
3. (Optional) Use the show event number num command to limit the number of lines that are
displayed. For example, to limit the event list to the most recent ten lines:
> show event number 10
Timestamp Type Category Message
---------------- ------- --------- --------------------------------------
-----
Nov 26 21:42:37
status stat
intf=eth1~type=ethernet~rx=11332435~tx=5038762
Nov 26 21:42:35
status system local_time=Thu, 08 Aug 2019 21:42:35
+0000~uptime=3 hours, 0 minutes, 48 seconds
...
>
4. (Optional) Use the show event table value command to limit the number of lines that are
displayed. Allowed values are error , info , and status . For example, to limit the event list to
only info messages:
> show event table info
Timestamp Type Category Message
---------------- ------- --------- --------------------------------------
-----
Nov 26 22:01:26
info user
name=admin~service=cli~state=opened~remote=192.168.1.2
Nov 26 22:01:25
info user
name=admin~service=cli~state=closed~remote=192.168.1.2
...
>
5. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu . Type quit to disconnect from the device.