Digi TX54, User Manual

Page: 886 / 1087

System administration Power ignition sensor
TX54 User Guide 886
Configure power delays for power ignition sensor
By default, the TX54 device automatically powers on when it detects power on the ignition sensor,
and powers off when it detects that there is no power on the ignition sensor, and there is no delay for
either power on or power off based on the power ignition sensor.
You can configure delays for powering on or off the system based on the state of the ignition sensor.
You can also temporarily override the configured delay to allow for one-time maintenance activities
(such as a firmware update) to occur after the ignition is switched off. See
Temporarily set the ignition
power delay for more information.

WebUI
1. Log into the TX54 WebUI as a user with full Admin access rights.
2. On the menu, click System . Under Configuration , click Device Configuration .
The Configuration window is displayed.
3. Click System > Power > Ignition sense control .
4. For Ignition power on delay , type the amount of time to wait to power on the device, after
the device detects that there is power on the ignition sensor.
Allowed values are any number of hours, minutes, or seconds, and take the format number
{ h|m|s }.
For example, to set Ignition power on delay to ten minutes, enter 10m or 600s .
The default is 0s , meaning that there is no power on delay.
5. For Ignition power off delay , type the amount of time to wait to power off the device, after
the device detects that there is no longer power on the ignition sensor.
Allowed values are any number of hours, minutes, or seconds, and take the format number
{ h|m|s }.
For example, to set Ignition power off delay to ten minutes, enter 10m or 600s .
The default is 0s , meaning that there is no power off delay.