ASDA-B2
Preface
Revision May, 2018
iii
Wiring
Please connect the ground terminal to class-3 ground system (under 100
Ω
);
poor grounding may result in electric shock or fire.
Do not connect the three-phase source to the motor output terminal U, V and
W. Or it is possible to cause personnel injury or fire.
Please tighten the screws of the power and motor output terminal. Or it is
possible to cause fire.
Operation
Before the operation, please change the parameter setting value according to
the needs. If it is not adjusted to the correct setting value, it is possible to lead
to malfunction of the machine or the operation might out of control.
Before the machine starts to operate, please be ensured the emergency stop
can be activated anytime.
During the operation, it is prohibited to touch any rotating motor parts.
Or it is possible to cause personnel injury.
In order to prevent any accident, please separate the couplings and belts of the
machine and isolate them. Then conduct the initial trial run.
If users fail to operate the machine properly after the servo motor connects to
the equipment, it would cause the damage of the equipment and lead to the
personnel injury.
In order to prevent the danger, it is strongly recommended to check if the motor
can operate normally without load first. Then, operate the motor with load.
Do not touch the heat sink of the servo drive. Or it is possible to cause scald
due to the high temperature.
Maintenance and Inspection
It is prohibited to touch the internal parts of the servo drive and servo motor.
Or it is possible to cause electric shock.
It is prohibited to disassemble the panel of the servo drive when turning on
the power. Or it is possible to cause electric shock.
Do not touch the ground terminal within 10 minutes after turning off the
power. Or the residual voltage may cause electric shock.
Do not disassemble the motor. Or it is possible to cause electric shock or
personnel injury.
Do not change the wiring when the power is on. Or it is possible to cause
electric shock or personnel injury.
Only the qualified electrical and electronics professionals can install, wire
and maintain the servo drive and servo motor.
