Chapter 4 Panel Display and Operation
ASDA-B2
4-4
Revision May, 2018
4.3.4 Positive and Negative Sign Setting
Display Symbol
Description
When entering into the Editing Setting Mode, pressing UP /
DOWN Key can increase or decrease the displayed content.
The SHIFT Key can change the desired adjusted carry value.
(The carry value is blinking at the moment.)
Pressing the SHIFT Key for two seconds can switch the positive
(+) and negative (-) sign. If the parameter is over the range after
switching the positive or negative sign, then it cannot be
switched.
4.3.5 Monitor Display
When the drive is applied to the power, the display will show the monitor displayed symbol
for a second, and then enter into the Monitor Mode. In Monitor Mode, the UP / DOWN Key
can change the desired monitor variable. Or, the user can directly change parameter P0-
02 to set the monitor code. When the power is applied, it will display ASDB2 first. When
the value of P0-02 is 4, it will display the pulse number of pulse command.
P0-02
Setting
Monitor Displayed
Symbol
Description
Unit
0
Motor feedback pulse number (after the
scaling of electronic gear ratio) (User unit)
[user unit]
1
Input pulse number of pulse command
(after the scaling of electronic gear ratio)
(User unit)
[user unit]
2
The difference of error pulse number
between control command pulse and
feedback pulse number (User unit)
[user unit]
3
Motor feedback pulse number (encoder
unit, 1600000 pulse/rev)
[pulse]
4
Input pulse number of pulse command
(before the scaling of electronic gear ratio)
(encoder unit)
[pulse]
5
Error pulse number (after the scaling of
electronic gear ratio) (encoder unit)
[pulse]
6
Input frequency of pulse command
[Kpps]
7
Motor speed
[r/min]
8
Speed input command
[Volt]
9
Speed input command
[r/min]
