InteliLite4 AMF20 Global Guide
72
Note:
This button will not change the mode if the controller mode is forced
by one of binary inputs listed in the Reference Guide – "Operating modes"
chapter.
RIGHT
button. Use this button to move right or to change the mode. The
button can change the mode only if the main screen with the indicator of
currently selected mode is displayed.
Note:
This button will not change the mode if the controller mode is forced
by one of binary inputs listed in the Reference Guide – "Operating modes"
chapter.
HORN RESET
button. Use this button to deactivate the horn output without
acknowledging the alarms.
FAULT RESET
button. Use this button to acknowledge alarms and
deactivate the horn output. Inactive alarms will disappear immediately and
status of active alarms will be changed to "confirmed" so they will disappear
as soon as their reasons dismiss.
UP
button. Use this button to move up or increase value.
PAGE
button. Use this button to switch over display pages.
DOWN
button. Use this button to move down or decrease value.
ENTER
button. Use this button to finish editing a setpoint or moving right in
the history page.
START
button. Works in MAN mode only. Press this button to initiate the
start sequence of the engine.
STOP
button. Works in MAN mode only. Press this button to initiate the stop
sequence of the Gen-set. Repeated pressing of button will cancel current
phase of stop sequence (like cooling) and next phase will continue.
GCB
button. Works in MAN mode only. Press this button to open or close
the GCB.
MCB
button. Works in MAN mode only. Press this button to open or close
the MCB.
Indicators and others
Position
Description
GENERATOR
status indicator. There are two states – Gen-set OK (indicator is green)
and Gen-set failure (indicator is red). Green LED is on if the generator voltage and
frequency is present and within limits. Red LED starts flashing when Gen-set failure
occurs. After FAULT RESET button is pressed, Red LED goes to steady light (if an alarm
