ComAp InteliLite 4 AMF 20, Global Manual

Page: 100 / 620

InteliLite4 AMF20 Global Guide
100
5.5 Functions
5.5.1 Operating Modes 100
5.5.2 Start-stop sequence 102
5.5.3 Engine start 104
5.5.4 Stabilization 108
5.5.5 Connecting to load 108
5.5.6 MRS operation 108
5.5.7 AMF operation 108
5.5.8 Engine cool down and stop 111
5.5.9 Gen-set operation states 111
5.5.10 Additional running engine indications 114
5.5.11 History log 114
5.5.12 Breaker control 116
5.5.13 Protections 119
5.5.14 Exercise timers 134
5.5.15 Voltage phase sequence detection 140
5.5.16 Load shedding 141
5.5.17 Dummy Load 142
5.5.18 Sensor curves 143
5.5.19 PLC 145
5.5.20 Geo-fencing 151
5.5.21 After-treatment Support 151
5.5.22 Alternate configuration 156
5.5.23 USB host 157
5.5.24 Firewall 161
5.5.25 E-Stop 161
5.5.26 ECU Frequency selection 162
5.5.27 User setpoints 162
6
back to Controller setup
5.5.1 Operating Modes
Selecting the operating mode is done with the Left and the Right buttons on the front panel or by
changing the Controller Mode (page 216) setpoint (from the front panel or remotely).
Note: If this setpoint is configured as password-protected, the correct password must be entered prior to
attempting to change the mode.
Note: The mode cannot be changed if Access Lock input is active.
The following binary inputs can be used to force one respective operating mode independent of the mode
setpoint selection:
Remote OFF (page 458)
Remote TEST (page 460)