Barco Encore, Manual

Page: 368 / 404

368 Encore Presentation System • User’s Guide
aK==tçêâáåÖ=táíÜ=aÉëíáå~íáçåë
ScreenPRO-II Configurations
fåíÉêå~ä=oçìíÉê=`çåÑáÖìê~íáçå
The diagram below illustrates an Encore configuration that uses two ScreenPRO-II units
with internal source routing. Each ScreenPRO-II is set up as a unique destination.
Figure D-1. ScreenPRO-II units using internal source routing
For an “internal routing” ScreenPRO-II configuration, please note the following points
regarding destination setup and source connections:
•
On the Destination Setup Menu :
~
Select Single Screen SP as the “ Type .”
~
Set the “ Routing Mode ” to Internal .
~
In Chapter 6, refer to the “ ScreenPRO-II Destination Setup ” section on
page 258 for instructions.
•
Connect analog and digital sources directly to each ScreenPRO-II.
•
ScreenPRO-II inputs are mapped using the Input Patch Menu :
~
If you are using D/As to connect sources to similar inputs on each
ScreenPRO-II, select
ALL SP as the “ Connection Type .”
~
If you are connecting to different inputs, separate input patches are
required for each.
~
In Chapter 6, refer to the “
Output Format Setup
” section on page 263
for instructions.
Encore Controller (SC or LC)
ScreenPRO-II
Analog Inputs 1-8
HD/SD Inputs 1-2
(HD Model Only)
Analog Inputs 1-8
HD/SD Inputs 1-2
(HD Model Only)
Internal Routing
Ethernet Switch
Side Screen 1
Side Screen 2