Phoenix v3.0 Upgrade Installation Instructions
Need
serial number
and
upgrade pin
number from current Phoenix to upgrade!
•
Power Phoenix on & immediately press and hold 0 to get to the
Feature Code
Menu
•
Feature Cod
e Screen enter: 0 0 0 0 0 to disable board and get upgrade pin
•
Enter Your PIN Code to confirm: _ _ _ _
•
Upgrade PIN
number will be displayed
Removing Old Board
•
Disconnect power supply and keypad cable from Phoenix
•
Flip unit over and remove 4 back screws
•
Flip unit over and remove front cover
•
Remove 4 board screws
•
Gently disconnect:
1) 8-pin output jack (multicolor cords)
2) LCD backlight (yellow/orange/red cable)
3) LCD power (yellow/orange/red cable)
4) Main Power connector (white)
•
Remove old board from Phoenix
Installing New Board
•
Reconnect cords to new board
1) 8-pin output jack (multicolor cords)
2) LCD backlight
(Yellow at the top & Red at bottom)
3) LCD power
(Yellow at the top & Red at bottom)
4) Main Power connector (white)
•
Replace 4 board screws –
DO NOT OVER TIGHTEN SCREWS
AS IT CAN BEND AND DAMAGE THE BOARD.
THIS
DAMAGE IS NOT COVERED UNDER WARRANTY!
•
Replace front cover, flip over and replace 4 back screws
MUST REPLACE FRONT COVER BEFORE POWERING
TOOL IN ORDER TO PREVENT TAMPER LOCKOUT MODE
