Barco Encore, Manual

Page: 265 / 404

Encore Presentation System • User’s Guide 265
6. System Setup
Genlock Setup
dÉåäçÅâ=pÉíìé
Encore system setup: Step 14
S
Prerequisites — Ensure that you are familiar with the Genlock Menu . In
Chapter 5, refer to the “ Genlock Menu ” section on page 151.
In this procedure, you will set up Genlock for each destination.
„
Use the following steps to set up Genlock:
1. In the System Keypad , press OUTPUT to display the Output Menu .
2. On the Destination Bus , select the destination that you want to configure.
3. Press
{
GLCK
}
to display the Genlock Menu .
4. For all types of destinations, set the genlock source on the Source line. Choose
between Black Burst , CSync or None .
5. For ScreenPRO-II destinations only, verify the setting of the ScreenPRO-II’s
Termination Switch on the
Termination line. The menu prompts you how to
change this physical switch on the ScreenPRO-II itself, if required.
6. Press
{
BACK
}
to return to the Output Menu .
7. Repeat from step 2 to set additional destination genlock types.
8. In the System Keypad , press
{
SAVE
}
to save the new configuration in memory.
14
Note When you select the Source, the Type line automatically
displays the type of genlock provided.