Barco Encore, Manual

Page: 252 / 404

252 Encore Presentation System • User’s Guide
6. System Setup
Router Setup
Stack configurations — please note:
~
Stacking is only available with the Controller LC.
~
When using a router with a single or wide screen “stack” configuration,
router outputs are required to go to all physical inputs for both the bottom
and top Processors, provided that all inputs are required to go to any
available layers.
The table below illustrates the default router output patch for a "stack"
configuration, where VP 2 is the “Top” Processor, and VP 1 is the “Bottom”
Processor:
18. To patch router outputs, use the following steps:
a. On the Router Output line, select the output that you want to patch.
b. If you are uncertain about the current patch, or if you want to remove the
current (existing) patch and start clean, press {
DELETE PATCH }.
c. On the Device ID line, select the Encore Processor or ScreenPRO-II ID
to which you want to patch the selected router output.
d. On the VP Input line, select the specific Encore Processor or
ScreenPRO-II input to which you want to patch the selected output.
e. Press { ADD PATCH } to confirm your changes. The new “mapping”
appears on the menu.
f. Repeat step 18 for all remaining router outputs that you wish to patch.
19. To designate a router output as an “Aux” output:
a. On the Router Output line, select the specific output that you want to
designate as an Aux output.
b. If you are uncertain about the current patch, or if you want to remove the
current (existing) patch and start clean, press {
DELETE PATCH }.
c. On the Device ID line, select None .
Table 6-1. Default output patch table
Router Output VP ID VP Input Mixer Layer
1 2 1A 6A
2 2 1B 6B
3 2 2A 5A
4 2 2B 5B
5 2 3A 4A
6 2 3B 4B
7 1 1A 3A
8 1 1B 3B
9 1 2A 2A
10 1 2B 2B
11 1 3A 1A
12 1 3B 1B