![background image](http://html1.mh-extra.com/html/barco/encore/encore_manual_3871756305.webp)
Encore Presentation System • User’s Guide
305
7. Operations
Working with Layers
8.
Source Size
— Press
Source
(in the
Joystick Section
) to display the
Key
Source Adjustment Menu
. Adjust the source image’s size and position within
the Key. In Chapter 5, refer to the "
Source Adjustment Menu Description
"
section on page 214 for menu details.
9.
Special Effects
— From the
Key
,
Key Adjustment
,
Key Source Adjustment
or
Matte Menu
, press {
EFX
} to display the
Image Effects Menu
. Select the desired
effect, including monochrome, chroma and hue, invert and strobe. In Chapter 5,
refer to the "
Image Effects Menu
" section on page 201 for details.
10.
Global Functions
— Remember that the following global functions are available:
~
Press
Reset
to reset the
current effect
(e.g., PIP, Key, crop, etc.) to a
nominal default value.
~
Press
Full Screen
to bring the Key to full screen, using the source’s
height as the defining factor.
~
Press
Freeze
to freeze the Key (on Program and Preview). Press again
to unfreeze.
11.
Transition
— Transition the new look to program with a
CUT
or
AUTO TRANS
.
Refer to the “
Working with Transitions
" section on page 320 for details.
`äÉ~êáåÖ=i~óÉêë=Ñêçã=mêçÖê~ã
The clear layer procedure enables you to remove layers from Program — including
backgrounds, layers and the DSK. When clearing layers, always remember to take
advantage of the system’s
Lookahead Preview
function. Refer to the "
Lookahead
Preview
" section on page 284 for additional details.
Use the following steps to clear a layer from Program:
1.
Check (and compare) the Program and Preview monitors, and note the layer(s)
that you wish to clear. In the
Layer Control Section
,
Red LEDs
above the
buttons indicate the layers that are on Program.
2.
If the button for the layer that you wish to clear is not lit, press to light it.
3.
In the
Layer Control Section
, press
Clear Layer
. This action turns off the
selected layer button and visually clears the layer from Preview. This step is valid
for all buttons in the
Layer Control Section
.
4.
Prior to transition, if you want to clear additional layers, repeat steps
2
and
3
.
5.
Transition the new setup to Program. The selected layer(s) will transition off of
Program.
Use the following steps to clear all layers from Program:
1.
In the
Layer Function
section, press
All + Clear Layer
(or
Clear Layer + All
).
2.
Perform an auto transition or a cut. All layers will transition off of Program.
Clear
Layer
Summary of Contents for Encore
