Barco Encore, Manual

Page: 315 / 404

Encore Presentation System • User’s Guide 315
7. Operations
Using Move
mÉåÇ=çå=mêçÖê~ã
This method enables you to trigger the move manually, with a layer already on Program.
„
Use the following steps to pend a move on Program:
1. With the move properly programmed, ensure that the layer containing a move is
selected and blinking.
2. Perform a CUT or AUTO TRANS .
3. To pend the move, press Move in the Layer Functions Section . The button
lights to indicate the pending move. On Preview, the raster box blinks at the
"destination" location —
not the PIP or Key’s current location.
4. Perform a CUT or AUTO TRANS . The move begins when the button is pressed.
5. To move the layer back to keyframe 1, press Move . The button lights and on
Preview, the raster box blinks at the "starting" location.
6. Perform a CUT or AUTO TRANS . In this "ping-pong" manner, you can continue
to transit back and forth between keyframes 1 and 2.
jçîÉ=kçíÉë
Please note the following important points regarding the Move mode:
•
Move parameters — for a given PIP, the following effects are valid "move"
parameters, each of which will transition smoothly from point to point:
~
PIP or Key size and position
~
PIP or Key source size and position
~
PIP Shadow size and position
~
PIP or Key Crop values
•
Keyframe effects — In addition to the “LINEAR” motion type, additional
predefined keyframe effects are available on the Effects Menu :
~
LINEAR ACCL — Same as LINEAR , but with acceleration and
deceleration.
~
ARCH CW — A smooth arch path moving in a clockwise direction.
~
ARCH CCW — A smooth arch path moving counter-clockwise.
~
BMRNG CW — A smooth boomerang motion, clockwise.
~
BMRNG CCW — A smooth boomerang motion, counter-clockwise.
•
Clearing moves — To clear a move (and remove the association between a layer
and a move), double-punch the Move Setup button quickly.
•
Raster size — If you define a PIP to transition to 0 x 0 size, the raster box
changes to a 4 x 4 pixel size. This enables you to know its location on the next
transition. The raster box change also occurs after you pend the move.
•
Freeze — You cannot set up a move or pend a move when a layer is frozen.
•
On screen, off screen — When programming moves, Encore lets you move a
PIP or Key from an off-screen location to an on-screen location, and vice-versa.
Note If you need to cancel the move (un-pend), simply press Move
to turn the button off.