Barco Encore, Manual

Page: 261 / 404

Encore Presentation System • User’s Guide 261
6. System Setup
AUX Destination Setup
fã~ÖÉmol=çê=mêÉmolJff=^ìñ=aÉëíáå~íáçå=pÉíìé
This section provides instructions for setting up ImagePRO Aux and PrePRO-II Aux
destinations. Once assigned, the associated button(s) on the Controller’s Destination
Bus will be active.
S
Prerequisites — Ensure that you are familiar with the ways in which
ImagePRO and PresentationPRO-II systems can be physically configured as
Aux destinations. In Appendix D:
~
Refer to the “ PresentationPRO-II Aux Configuration ” section on
page 372 for PresentationPRO-II details.
~
Refer to the “ ImagePRO Aux Configuration ” section on page 373 for
ImagePRO details.
„
Use the following steps to set up an ImagePRO or PrePRO-II Aux destination:
1. Ensure that your ImagePRO and/or PresentationPRO-II systems are properly
connected to the system
Switch via Ethernet. If not, in Chapter 3, refer to the
“ Installation ” section on page 54 for instructions.
2. Ensure that you have properly configured one (or more) router outputs as “Aux”
outputs. If not, refer to the “
Router Setup ” section on page 250 for instructions.
Step 19 deals specifically with Aux output setup.
3. In the System Keypad , press SYSTEM to access the System Menu .
4. Press
{
DEST SETUP
}
to display the Destination Setup Menu .
5. On the Destination line, select the Aux destination that you want to define.
6. Scroll to the Type line and select ImagePRO Aux or PrePRO-II Aux .
7. Press { AUX SETUP } to display the Aux Setup Menu .
8. On the Source Mapping line, two choices are available:
~
Select Input Patch if you want to map Aux sources according to how
inputs are patched to buttons on the Source Selection Bus . Note that
this is the typical choice.
~
Select Direct Map if you want the Source Selection bus to be a 1:1
mapping of your router inputs — for this Aux destination only.
9. On the ID line, select the ID of the ImagePRO or PrePRO -II to which you want to
route Aux sources.
10. In the Analog section:
a. On the Analog Router Name line, select the router from which analog
sources will be routed to the ImagePRO (or PrePRO-II).
b. On the Analog Router Output line, select the specific router output that
you designated as an Aux output.
c. On the ImagePRO Input (or PrePRO-II Input ) line, select the
ImagePRO or PrePRO-II input to which the analog router output is
connected.
Note On the Controller SC, up to 6 destinations can be assigned.
On the Controller LC, up to 32 destinations can be assigned.