Barco Encore, Manual

Page: 93 / 404

Encore Presentation System • User’s Guide 93
3. Hardware Installation
Program and Source Link Connections
`çååÉÅíáåÖ=mêçÖê~ã=~åÇ=pçìêÅÉ=iáåâë
This section provides instructions for connecting Program Link and Source Link
connections in a variety of Encore configurations.
•
Left Justified Configuration
•
Center Justified Configuration
iÉÑí=gìëíáÑáÉÇ=`çåÑáÖìê~íáçå
Left justification means that the first pixels of the projected image begin immediately at the
left, and that unused source material is removed from the far right of the image. A two-
projector sample is illustrated below.
Figure 3-13. Left Justification
Please note:
•
Left justified systems are connected in daisy-chain fashion.
•
Up to 32 Encore Video Processors are supported.
„
Use the following steps to connect Program and Source Links for left justification:
1. Program Link Connections
Connect the Program Link Out connector on Processor 1 to the Program Link
In connector on Processor 2, as illustrated below.
Figure 3-14. Program Link Connections
2. Repeat the procedure for all remaining Processors in your configuration.
3. For the last processor in the chain, do not connect the Program Link Out
connector.
Important Secure all cable connections tightly to ensure reliable
operation. This is important especially for the Program and
Source links — as box-to-box synchronization is relayed in
these cables for wide screen setups.
båÅçêÉ
Projector 1
Image
Unused
Source
Material
Image
Overlap
Region
Projector 2
Image
Processor 1
Program
Link Out
Program
Link In
Processor 2
Program
Link Out
Program
Link In
Processor [n]
Program
Link Out
Program
Link In