![background image](http://html1.mh-extra.com/html/barco/encore/encore_manual_3871756242.webp)
242
Encore Presentation System • User’s Guide
6. System Setup
ID Setup and Remote Enable
fa=pÉíìé=~åÇ=oÉãçíÉ=bå~ÄäÉ=
Encore system setup:
Step 1
.
In this procedure, you will set up individual Encore Video Processor IDs. If ScreenPRO-II,
PresentationPRO-II and/or ImagePRO units are used as destinations, you will also set their
IDs and enable remote control. Each unit in your system must have a unique ID.
Use the following steps to set up IDs and remote control:
1.
Power up your Encore Controller, and allow it to fully boot up. This is the system’s
DHCP server.
2.
To set Encore Video Processor IDs:
a.
Using the
Unit ID Selector
on the rear of each Processor, set the
desired
ID
. Logical IDs
1
-
16
are available.
b.
If you elect to use “extended” IDs 17 - 32, use the
Video Processors ID
Definition Menu
to redefine the IDs. In Chapter 5, refer to the “
Video
Processors ID Definition Menu
” section on page 185 for details.
c.
Repeat step
3
for all other Video Processors in your system.
3.
Power up all Encore Video Processors, ScreenPRO-II units, PresentationPRO-II
units and ImagePRO units in your system. This sequence enables the Encore
Controller to “serve” IP addresses to the Processors and other peripherals.
4.
To set ScreenPRO-II and PresentationPRO-II IDs and enable remote control:
a.
Ensure that the ScreenPRO-II and PresentationPRO-II units are
connected to the same Ethernet Switch as the Video Processor(s).
b.
Press {
REMOTE CONTROL
} on the
Home Menu
to access the
Remote
Control Menu
.
c.
Scroll to the
Unit ID
line, and select a unique ID. The ID range is
1
to
32
.
d.
Scroll to the
Remote Control/DHCP
line, and enable remote control.
e.
Press {
SAVE
} to save the system state in non-volatile memory — so that
it will return to it should power need to be cycled.
f.
Repeat step
4
for all other ScreenPRO-II and PresentationPRO-II units in
your system.
5.
To set ImagePRO IDs and enable remote control:
a.
Ensure that the ImagePRO units are connected to the same Ethernet
Switch as the Video Processor(s).
1
Important
If you are setting up a “stack” configuration, the ID of the
bottom stack Video Processor must always be lower than the
ID of the top stack Processor.
Note
When remote control is on, the {
HOME
} buttons disappears,
the ScreenPRO-II (or PresentationPRO-II) front panel is
disabled, and the unit’s IP address is dynamically assigned.
All control now originates from Encore’s console.
Summary of Contents for Encore
