Barco Encore, Manual

Page: 256 / 404

256 Encore Presentation System • User’s Guide
6. System Setup
Input Patching
„
Use the following steps to patch inputs to specific source buttons:
1. In the System Keypad , press SYSTEM to display the System Menu .
2. Press { INPUT PATCH } to display the Input Source Patch Menu .
3. On the Source Number line, select the source button on the Controller that you
want to patch.
4. (Optional) If required, press
{
DELETE PATCH
}
to clear all registers for a selected
source button. This enables you to start again with an “undefined” patch.
5. On the Connection Type line, select the router, ScreenPRO-II or the physical
connector that you want the selected button to communicate with. Four options
are available:
~
Select a router by name (e.g., MatrixPRO1 ).
~
Select a DIRECT SDI, Analog or DVI connection.
~
Select an individual ScreenPRO-II ID (e.g., SP 9 ).
~
Select ALL SP . This selection assumes connections from D/As to similar
inputs on all ScreenPRO-IIs in your system.
6. If you selected a router:
a. On the Router Input line, select the physical router input that you wish to
associate with the source button.
b. Continue with step 10 .
7. If you selected a DIRECT connection:
a. On the ID line, choose the ID of the Video Processor or ScreenPRO-II
that you want to address.
b. Select the input to which the source is physically connected:
• If you chose the ID of a Video Processor , on the VP Input line,
select the specific M/E input connector on the Processor
• If you chose the ID of a ScreenPRO-II , on the SP Input line,
select the specific input connector on the ScreenPRO-II.
c. Continue with step 10 .
8. If you selected an individual ScreenPRO-II ID :
a. On the SP Input line, select the specific input connector on the
ScreenPRO-II.
b. Continue with step 10 .
9. If you selected ALL SP :
a. On the ScreenPRO-II Input line, select the “common” input connector
on all ScreenPRO-IIs to which the sources are physically connected.
b. Continue with step 10 .
10. On the Tally Number line, select the tally that you want to associate with the
source button. (If tallies are not connected, in Appendix A, refer to the “ Tally
Connector ” section on page 351 for pinout details.)
11. Press { ADD PATCH } to confirm your changes.
12. Repeat the procedure from step 3 to patch additional Controller buttons.
13. Press
{
BACK
}
to return to the System Menu .
14. In the System Keypad , press SAVE to save the new configuration in memory.