Barco Encore, Manual

Page: 372 / 404

372 Encore Presentation System • User’s Guide
aK==tçêâáåÖ=táíÜ=aÉëíáå~íáçåë
PresentationPRO-II Aux Configuration
mêÉëÉåí~íáçåmolJff=^ìñ=`çåÑáÖìê~íáçå
PresentationPRO-II units can be connected to the Encore Controller via Ethernet for use as
Aux destinations. In this manner, AUX outputs from up to two routers are connected to the
PresentationPRO-II — so that any available source used in the Encore system can be
displayed on a given monitor.
The diagram below shows a PresentationPRO-II Aux configuration that uses one analog
router and one SDI router.
Figure D-5. PresentationPRO-II Aux connections
„
Use the following steps to properly prepare a PresentationPRO-II system for setup as
an Aux destination:
1. Ensure that you are running software Version 1.12 (or above) on the
PresentationPRO-II. If not, download software in the normal manner from the
FTP site (
ftp.folsom.com ) or the web site ( www.barco.com ).
2. On each router (1 x Analog, 1 x SDI), ensure that an unused router output is
physically connected to a PresentationPRO-II input. Make a note of these
connection patches, as they will need to be entered during the setup procedure.
3. Before you connect the PresentationPRO-II to the Encore Controller, set up the
PresentationPRO-II’s output resolution at the unit itself. Ensure that you match
the resolution of the monitor connected to the system.
4. On PresentationPRO-II’s Effects Menu , set up the transition parameters that the
unit will use when AUTO TRANS is pushed on the Encore Controller.
5. (Optional) If a BG (background) or DSK (Downstream Key) needs to be on
Program at all times, set up this input on the PresentationPRO-II, and transition it
to Program — prior to placing the PresentationPRO-II into remote control mode.
6. Complete the setup procedure by setting up the Aux destination(s) on the Encore
Controller. In Chapter 6, refer to the “
AUX Destination Setup ” section on
page 259 for instructions.
MatrixPRO SDI Router
MatrixPRO Analog Router
Encore Controller (SC or LC)
PresentationPRO-II
Ethernet Switch
Monitor
Router
Outputs
Inputs
SDI
Inputs
Analog
Inputs