Barco Encore, Manual

Page: 369 / 404

Encore Presentation System • User’s Guide 369
aK==tçêâáåÖ=táíÜ=aÉëíáå~íáçåë
ScreenPRO-II Configurations
bñíÉêå~ä=pÉêá~ä=oçìíÉê=`çåÑáÖìê~íáçå
The diagram below shows a configuration that uses two ScreenPRO-II units with external
source routing. Each ScreenPRO-II is set up as a unique destination.
In this configuration, two external serial (RS-232) routers are used — one for analog
connections and one for SDI source connections to each ScreenPRO-II. Because
two
serial connections are required, a Lantronix UDS200 is used.
Figure D-2. ScreenPRO-II units using external serial controlled routers
For an “external routing” configuration with serial controlled routers, please note the
following points regarding destination setup and source connections:
•
On the Destination Setup Menu :
~
Select Single Screen SP as the “ Type .”
~
Set the “ Routing Mode ” to External .
~
In Chapter 6, refer to the “ ScreenPRO-II Destination Setup ” section on
page 258 for instructions.
•
Connect analog and digital sources to each router in the normal manner.
•
For each router, connect two outputs to each ScreenPRO-II.
•
On the Router Specification Menu , select the correct router and manufacturer,
and set the “ Communication Type ” to LANTRONIX . In Chapter 6, refer to the
“ Router Setup ” section on page 250 for instructions.
•
Router outputs are mapped using the Output Patch Menu . This menu defines
which router output connects to which ScreenPRO-II input. In Chapter 6, refer to
the “
Router Setup ” section on page 250 for instructions.
•
Router inputs are mapped using the Input Patch Menu . In Chapter 6, refer to the
“ Output Format Setup ” section on page 263 for instructions.
MatrixPRO SDI Router
MatrixPRO Analog Router
RS-232
Lantronix
UDS200
Ethernet
Encore Controller (SC or LC)
ScreenPRO-II
Ethernet Switch
Side Screen 1
Side Screen 2
Router
Outputs
Inputs
RS-232
SDI
Inputs
Analog
Inputs