Barco Encore, Manual

Page: 117 / 404

Encore Presentation System • User’s Guide 117
4. Controller Orientation
Controller Sections
Following are descriptions of each button’s function on the Source Selection Bus .
Source Buttons — press to assign the source to the blinking “mixer” button in the Layer
Control Section .
•
When the source button is lit and blinking :
~
The source is on Preview.
~
The associated layer is active for modification.
~
The associated layer’s raster box is blinking on Preview.
•
When lit solid, the source is on Preview — but its associated layer is not active for
modification.
•
Multiple source buttons can be lit simultaneously, but only one source button can
be blinking — with its associated layer active for modification and the associated
raster box blinking on Preview.
•
When the Red LED above a source button is lit solid, the source is on Program.
•
When the Red LED above a source button is blinking :
~
The associated mixer is set to Mix Mode .
~
In the mixer, the blinking Red LED indicates the layer that is on Program.
~
In the associated mixer, the layer opposite to the blinking Red LED is
enabled for modification, with the associated raster box blinking.
S
The Red LED above source 1 is blinking, and the Red LED above layer 1A is
blinking. This indicates that mixer 1 is set to Mix Mode , with source 1 on
Program in layer 1A and layer 1B active for modification.
•
Multiple Red LEDs can be lit simultaneously, but only one Red LED can be
blinking — indicating a “Mix Mode” association.
•
Source buttons cannot be selected if they have not been assigned during the
source setup procedure. The button(s) will not light.
Source buttons are also used in the following modes:
•
Source buttons can be used to route inputs to selected Aux destinations. In
Chapter 7, refer to the “ Routing Sources to Aux Destinations ” section on
page 294 for details.
•
In “live switch” mode, source buttons can be used to switch the input to a PIP
directly on Program. In Chapter 7, refer to the “
Working with Live Modes ”
section on page 317 for complete instructions on all destination modes.
Shift — the Shift button is a toggle: press once to light, press again to turn off. When lit,
press the desired source button to access the second row of numbered sources (e.g., 13 -
24 on the Controller SC).
In Chapter 7, refer to the “ Switching Sources ” section on page 297 for additional details.
17
49
Note Without the blinking Red LEDs in Mix Mode, you would not
be able to tell which layer/source combination was on
Program in the selected mixer.
Shift