![background image](http://html1.mh-extra.com/html/barco/encore/encore_manual_3871756078.webp)
78
Encore Presentation System • User’s Guide
3. Hardware Installation
Installation
b.
On the second stack:
•
Connect the bottom stack’s
DVI Preview Output
to the top
stack’s Background 1 input (
3A
).
•
Connect the bottom stack’s
DVI Program Output
to the top
stack’s Background 2 input (
3B
).
8. D/A Connections —
a.
If your system includes analog, SDI or DVI D/As, connect video inputs to
the D/As as required.
b.
Connect D/A outputs to the to the desired M/E input connectors on the
first stack only.
9. Router
Connections
— if you elect to use router connections, in place of (or in
addition to) direct connections:
a.
For Ethernet controlled routers:
•
Ensure that the router(s) are connected to the same Ethernet
Switch as the Controller and Processors.
•
Ensure that each router has an unique IP address.
b.
To connect a single serial controlled router, use an RS-232 cable to
connect the router to the Controller’s
EXT COMM
port. In Chapter 2,
refer to the “
Controller Rear Panels
” section on page 49 for details.
c.
To connect two (or more) serial routers, a third-party Ethernet-to-Serial
converter is required, such as the
Lantronix
model
UDS100
or
UDS200
(
http://www.lantronix.com/pdf/UDS200_PB.pdf
). Note that each
UDS200
can control two serial routers.
•
Using RS-232 cables, connect each router to the
UDS200
.
•
Set up a static IP address on the Lantronix. The recommended
range is
192.168.0.191 - 192.168.0.240
— so as not to conflict
with other devices.
•
Using an Ethernet cable, connect the
UDS200
to the same
Ethernet Switch as the Controller and Processors.
d.
Ensure that all sources are connected to your router(s).
e.
Connect all selected router outputs to the desired M/E inputs on the first
stack only:
•
For PIPs 1 - 6, connect router outputs to the desired M/E inputs
on the “
bottom stack
” Processor.
•
For PIPs 7 - 12, connect router outputs to the desired M/E
inputs on the “
top stack
” Processor.
f.
If your configuration includes one (or more) ScreenPRO-II units as
unique destinations, connect two outputs from each router to each
ScreenPRO-II.
10. ScreenPRO-II Connections
— if your system includes one (or more)
ScreenPRO-II units as unique destinations, you can configure the ScreenPRO-II
for internal or external source routing:
a.
When
External
routers are used, connect two outputs from an Analog
router to
any two HD-15 inputs
on ScreenPRO-II. An SDI router can
also be connected to BNC inputs
1
and
2
. During setup, these specific
patches will be defined using the
Output Patch Menu
.
Summary of Contents for Encore
