Barco Encore, Manual

Page: 373 / 404

Encore Presentation System • User’s Guide 373
aK==tçêâáåÖ=táíÜ=aÉëíáå~íáçåë
ImagePRO Aux Configuration
fã~ÖÉmol=^ìñ=`çåÑáÖìê~íáçå
ImagePRO units can be connected to the Encore Controller via Ethernet for use as Aux
destinations. In this manner, AUX outputs from up to three routers are connected to the
ImagePRO — so that any available source used in the Encore system can be displayed on
a given monitor.
The diagram below shows a ImagePRO Aux configuration that uses one analog router, one
DVI router and one SDI router.
Figure D-6. ImagePRO Aux connections
„
Use the following steps to properly prepare an ImagePRO system for setup as an Aux
destination:
1. Ensure that you are running software Version 2.30 (or above) on the ImagePRO.
If not, download software in the normal manner from the FTP site
(
ftp.folsom.com ) or the web site ( www.barco.com ).
2. On each router (1 x Analog, 1 x SDI, 1 x DVI), ensure that an unused router output
is physically connected to an ImagePRO input. Make a note of these connection
patches, as they will need to be entered during the setup procedure.
3. Before you connect the ImagePRO to the Encore Controller, set up the
ImagePRO’s output resolution at the unit itself. Ensure that you match the
resolution of the monitor connected to the system.
4. On ImagePRO’s Effects Menu , set up the transition parameters that the unit will
use when AUTO TRANS is pushed on the Encore Controller.
5. Complete the setup procedure by setting up the Aux destination(s) on the Encore
Controller. In Chapter 6, refer to the “
AUX Destination Setup ” section on
page 259 for instructions.
MatrixPRO SDI Router
MatrixPRO Analog Router
Encore Controller (SC or LC)
ImagePRO
Ethernet Switch
Monitor
Router
Outputs
Inputs
SDI
Inputs
Analog
Inputs
MatrixPRO DVI Router
DVI
Inputs