Barco Encore, Manual

Page: 64 / 404

64 Encore Presentation System • User’s Guide
3. Hardware Installation
Installation
• Connect the computer’s “head 3” to Processor 3, input 3A
d. The DSK source may originate from a computer with a multi-head
graphics card, but it is not a requirement.
S
Connecting a single-head graphics card to Processor 3 only would
enable a bug to be placed
only in that screen space.
If you elect to use a multi-head graphics card for the DSK source, ensure
that you connect to the same input on each Processor — to the highest
priority M/E (M/E 1).
S
To connect an unscaled DSK source in a triple Processor system
(each Processor with three M/Es):
• Connect the computer’s “head 1” to Processor 1, input 1A
• Connect the computer’s “head 2” to Processor 2, input 1A
• Connect the computer’s “head 3” to Processor 3, input 1A
7. D/A Connections —
a. If your system includes analog, SDI or DVI D/As, connect video inputs to
the D/As as required.
b. Connect D/A outputs to the to the desired M/E input connectors.
8. Router Connections — if you elect to use router connections, in place of (or in
addition to) direct connections:
a. For Ethernet controlled routers:
• Ensure that the router(s) are connected to the same Ethernet
Switch as the Controller and Processors.
• Ensure that each router has an unique IP address.
b. To connect a single serial controlled router, use an RS-232 cable to
connect the router to the Controller’s
EXT COMM port. In Chapter 2,
refer to the “ Controller Rear Panels ” section on page 49 for details.
c. To connect two (or more) serial routers, a third-party Ethernet-to-Serial
converter is required, such as the
Lantronix model UDS100 or UDS200
( http://www.lantronix.com/pdf/UDS200_PB.pdf ). Note that each
UDS200 can control two serial routers.
• Using RS-232 cables, connect each router to the UDS200 .
• Set up a static IP address on the Lantronix. The recommended
range is
192.168.0.191 - 192.168.0.240 . Refer to the
Lantronix User’s Guide for instructions.
Note Input 3A resides on the lowest priority M/E in a 3 M/E system.
To connect a
second background, use input 3B.
Note The DSK Setup Menu allows you to pick an individual ID
within a widescreen on which to perform DSK setup.
Note Input 1A resides on the highest priority M/E in a 3 M/E Encore
system. If you wish to connect a
backup DSK, use input 1B.