Azbil MagneW Neo PLUS, User Manual

Page: 276 / 338

Operation using HART communicator Azbil Corporation
7-10 Model MTG11A/18A, MTG11B/18B, MTG14C
Selecting display
The display selection is set as follows:
Selecting function
Pulse output and contact output can be selected.
Follow the procedures described below to select pulse output or contact output.
1. From online menu,
Select:
1. Device setup
3. Basic setup
7. Display select
Figure 7-14 will then be displayed.
Figure 7-14
2. Once the display as shown in Figure 7-14 appears, move the arrow key up or
down to select a display. After making a selection, press F4 (ENTER). % /
Rate / TOTAL can be selected. If F3 (ESC) is pressed here, the selection will
be canceled and the display will return to the basic menu.
3. After returning to the basic setup menu, press F2 (SEND). Changed setting
will be transmitted to the converter. The HART Communicator mark will
appear on the upper right hand corner while HART is communicating with the
device. The mark will disappear once communication has properly completed.
1. From online menu,
Select:
1. Device setup
3. Basic setup
8. Func set
Figure 7-15 will then be displayed.
Figure 7-15
2. Once the display as shown in Figure 7-15 appears, move the arrow key up or
down to select a display. After making a selection, press F4 (ENTER). Pulse
(Pulse output), Hi Lo ST out (contact output), or Electrode ST out (contact
output) can be selected. If F3 (ESC) is pressed here, the selection will be
canceled and the display will return to the basic menu.
3. After returning to the basic setup menu, press F2 (SEND). Changed setting
will be transmitted to the converter. The HART Communicator mark will
appear on the upper right hand corner while HART is communicating with the
device. The mark will disappear once communication has properly completed.
CM2-MTG300-2001.book 10 ページ ２０１５年９月２９日 火曜日 午前１０時１４分