Azbil MagneW Neo PLUS, User Manual

Page: 196 / 338

Operation using the data setting device Azbil Corporation
6-12 Model MTG11A/18A, MTG11B/18B, MTG14C
6-1-5: Before operating SFC
Before SFC operation, please read the following:
Status of two wired magnetic flowmeter SFC at SFC communication
Make sure that the two wired magnetic flowmeter is in the Measuring Mode while
setting it using the SFC communication.
If communicating with the other mode, SFC will display “IN LOCAL MODE” on the
screen and you cannot set or change using SFC communication. In this case, change
the two wired magnetic flowmeter in the field to Measuring mode and then, try to
communicate again.
Two wired magnetic flowmeter will take this status “LOCAL”, as someone setting or
changing by touch sensor in the field. This is to prevent the setting and changing
operation from both sides.
Confirm write protect mode
Two wired magnetic flowmeter has a write protect function. Write protect function is
to prevent access to unauthorized persons and to prevent performing wrong operation.
Write protect can be set by the customer by setting the arbitrary 4 levels.
Please make sure that when write protect level is WP0, reading and writing are
available and when write protect level is WP1, 2 or 3, only reading is available.
The protection details are shown by write protect levels.
R/W: Read and write (Read and write set values)
R: Read
W: Write
ENABLE: Enabled
DISABLE: Disabled
ONLY: Only the indicated operation is enabled.
Write
protect
level
SW1 SW2
LSC (Key operation) Communication
Operator’s
mode
Engineering
mode
Maintenance
mode
Operator’s
mode
Engineering
mode
Maintenance
mode
0 OFF OFF
R/W
ENABLE
R/W
ENABLE
R/W
ENABLE
R/W
ENABLE
R/W
ENABLE
R/W
ENABLE
1 ON OFF
R/W
ENABLE
R/W
ENABLE
R/W
DISABLE
R
ONLY
R
ONLY
R
ONLY
2 OFF ON
R/W
ENABLE
R
ONLY
R/W
DISABLE
R
ONLY
R
ONLY
R
ONLY
3 ON ON
R
ONLY
R
ONLY
R/W
DISABLE
R
ONLY
R
ONLY
R
ONLY
CM2-MTG300-2001.book 12 ページ ２０１５年９月２９日 火曜日 午前１０時１４分