Azbil MagneW Neo PLUS, User Manual

Page: 212 / 338

Operation using the data setting device Azbil Corporation
6-28 Model MTG11A/18A, MTG11B/18B, MTG14C
Loop check of output signal
Introduction
The converter is provided with a function of a constant current generator. As the
magnitude of a current that can be generated, an arbitrary value of 0 to 100% of the
flow rate signal can be set. A loop check can be made using this function.
Used when
Use this function to check the connection status or the operation of devices connected
to the converter in the measured loop.
Operation
This function is operated from the SFC. Use the following procedure.
Step Key Procedure SFC screen
1 Make sure that the SFC is set to
“READY”.
If a screen other than the one as shown
on the right is displayed, press the
key.
2
Press the key.
3 Press numeric keys to enter the value of
a signal current to be generated in
percentage.
The example to the right shows a case
where a current equivalent to 25% flow
rate is generated.
4
Press the key.
This generates a constant current output
from the converter. A “#” mark is
displayed on the screen during the
output.
5 To cancel the constant current output,
press and then press the key.
When the constant current output is
canceled, the “#” mark on the screen
disappears.
Be sure to perform this operation at the
end of the loop check.
However, even if the instrument is left
without performing this operation, the
current output is automatically canceled
after 10 minutes.
CLR
( No )
CLR
( No )
SFCM00006009D
OUT- J
PUT
INPUT
OUT- J
PUT
INPUT
SFCM00006068D
SFCM00006011D
ENTER
( Yes )
NON-VOL
ENTER
( Yes )
NON-VOL
SFCM00006069D
OUT- J
PUT
INPUT
CLR
( No )
OUT- J
PUT
INPUT
CLR
( No )
SFCM00006009D
CM2-MTG300-2001.book 28 ページ ２０１５年９月２９日 火曜日 午前１０時１４分