Azbil MagneW Neo PLUS, User Manual

Page: 290 / 338

Operation using HART communicator Azbil Corporation
7-24 Model MTG11A/18A, MTG11B/18B, MTG14C
Low alarm value setting
To set the low alarm value of contact output, proceed as follows:
Contact output status setting
To select OPEN/CLOSE of contact output in normal status, proceed as follows:
1. From online menu,
Select:
1. Device setup
4. Detailed setup
2. Conf output
4. Digital output
2. Low alarm
Figure 7-39 will then be displayed.
Figure 7-39
2. Use the numeric keys to enter a high alarm value in the value input display.
Setting range of high alarm value is 0% to +115%. Do not set the value to be
High alarm value < Low alarm value.
3. Once a new value is entered, press F4 (ENTER) to return to the Digital output
menu. When the value is outside the range, error will be displayed. Input the
value again.
4. After returning to the Digital output menu, press F2 (SEND). Changed setting
will be transmitted to the converter. The HART communicator mark will
appear on the upper right hand corner while HART is communicating with the
device. The mark will disappear once communication has properly completed.
1. From online menu,
Select:
1. Device setup
4. Detailed setup
2. Conf output
4. Digital output
3. Burn out DO
Figure 7-40 will then be displayed.
Figure 7-40
2. Once the display as shown in Figure 7-40 appears, move the arrow key up or
down to select OPEN or CLOSE. After making a selection, press F4
(ENTER). If F3 (ESC) is pressed here, the selection will be canceled and the
display will return to the Digital output menu.
3. After returning to the Digital output menu, press F2 (SEND). Changed setting
will be transmitted to the converter. The HART communicator mark will
appear on the upper right hand corner while HART is communicating with the
device. The mark will disappear once communication has properly completed.
CM2-MTG300-2001.book 24 ページ ２０１５年９月２９日 火曜日 午前１０時１４分