Azbil MagneW Neo PLUS, User Manual

Page: 200 / 338

Operation using the data setting device Azbil Corporation
6-16 Model MTG11A/18A, MTG11B/18B, MTG14C
CONFIG functions
The CONFIG functions that are entered by pressing the key include the
following 17 sub-functions.
UNIT KEY: Select unit system and setting of specific gravity............6-42
CUT OFF: Sets and changes low flow ..............................................6-44
DISP: Changes flow rate display................................................6-46
EX (mA): Sets detector constant ......................................................6-48
TYPE: Sets detector type.............................................................6-50
DIAMETER: Sets detector diameter......................................................6-52
ALARM CONFIG: Sets high alarm and low alarm values .............................6-54
F/S SETUP: Sets fail-safe direction .....................................................6-56
DIGITAL I/O: Select pulse output and contact output ............................6-60
Sets contact output status.................................................6-62
DI/DO CHECK: Output check of contact output .......................................6-64
CORRECT DAC: Analog output calibration ................................................6-66
GAIN CAL: Gain calibration ...............................................................6-68
SHIP DATA RECOV:Resets internal data setting to factory setting .................6-70
READ TOTAL: Reads flow rate counter value..........................................6-71
PULSE OUTPUT: Checks pulse output value ...............................................6-72
PULSE CONFIGURE:Sets pulse scale and pulse scale unit ..............................6-74
Sets pulse width ...............................................................6-76
Sets dropout .....................................................................6-78
RESET TOTALIZE: Resets flow rate counter................................................... 6-80
m
CAUTION
• Do not operate the following screen from the calibration menu. Operating this
screen will erase all data entered in the electromagnetic flow meter.
B
CONF
SFCM00006003D
CM2-MTG300-2001.book 16 ページ ２０１５年９月２９日 火曜日 午前１０時１４分