Azbil MagneW Neo PLUS, User Manual

Page: 112 / 338

Operation using the data setting device Azbil Corporation
5-6 Model MTG11A/18A, MTG11B/18B, MTG14C
This section describes keys on the data setting device.
Name Description
MODE key • Enters OPERATOR'S MODE.
• When parameters and configured data have been
changed in ENGINEERING MODE or
MAINTENANCE MODE, press this key to save the
data.
Right shift key • Moves the cursor to the right.
Decrement key • Changes the parameter at a cursor position.
• Displays the previous screen.
If the key is pressed, when the
cursor is placed at the upper
left end (*, #, >), the screen
will change
If the key is pressed, when the
cursor is placed at a number,
the number is decremented.
If the cursor is placed at a
decimal point, the decimal
point moves rightward.
Increment key
• Changes the parameter at a cursor position.
• Displays the following screen.
If the key is pressed, when the
cursor is placed at the upper
left end (*, #, >), the screen
will change.
If the key is pressed, when the
cursor is placed at a number,
the number is incremented.
If the key is pressed, when the
cursor is placed at a decimal
point, the decimal point
moves to the left.
If the cursor is placed over
READY, pressing the key
starts operation.
* OPERATOR'S
MODE
Cursor
* DAMPING
001.0 S
Cursor
# 1.0000 m/s
SPAN 07. 069 m
3 /h
Cursor
* OPERATOR'S
MODE
Cursor
* DAMPING
001.0 S
Cursor
# 1.0000 m/s
SPAN 07. 069 m
3 /h
Cursor
* AUTO ZERO
READY
Cursor
CM2-MTG300-2001.book 6 ページ ２０１５年９月２９日 火曜日 午前１０時１４分