6-18
CD021
3. Using a snap ring pliers, remove the snap ring
securing the bearing ring to the shaft. Note the
direction of the bearing for assembling purposes.
CD023
4. Note the difference inside each bearing ring end
for assembling purposes; then remove the bearing
ring.
NOTE: The recess of the bearing must face
toward the housing.
CD022
5. Inspect the splines of the shaft, the bearing ring,
and the housing for damage.
NOTE: If any damage is apparent to the splines,
the bearing ring, and/or the housing, the drive axle
must be replaced as an assembly.
6. Using a side-cutters (or suitable substitute),
remove the small clamp from the shaft.
CD752
NOTE: At this point if the outside boot is dam-
aged, continue with step 7.
7. Using a side-cutters (or suitable substitute),
remove both outside boot clamps from the shaft.
Note the position of the different-sized clamps for
assembling purposes.
CD751
8. Apply 40 grams (1/3 of contents) of grease from
the Grease Pack into the knuckles and the new out-
side boot.
ATV-1052
Next
Back
Section
Table of Contents
Manual
Table of Contents
