3-142
GZ280B
GZ336
9. Engage the shift forks into the gear shift shaft and
push the shift fork shaft into the crankcase.
GZ339
Joining Crankcase
Halves
(Gen. I)
1. Using rubber bands, support the connecting rods to
align with the cylinder bores.
GZ340
2. Coat both sides with motor oil; then install the
spacer washer on the crankshaft with the radius
directed toward the crankshaft.
GZ341
3. Install the two alignment pins; then apply a thin
bead of silicone sealant to the crankcase mating
surface.
GZ345A
AT THIS POINT
Proper transmission shifting should be verified by
turning the gear shift shaft to select High, Low, Neu-
tral, and Reverse while rotating the input shaft and
observing the countershaft rotation.
AT THIS POINT
The right-side crankcase is now ready for installation
to the left-side crankcase. Proceed to Joining Crank-
case Halves (Gen. II).
Next
Back
Section
Table of Contents
Manual
Table of Contents
