3-130
3. Remove the snap ring securing the water pump
idler shaft (C) in the crankcase; then remove the
shaft and bearings.
GZ463A
4. Remove the snap ring securing the oil pump
driven gear (D) to the oil pump driveshaft; then
remove the gear. Account for a drive pin and
washer.
GZ463B
5. Remove the shift fork shaft (E); then remove the
gear shift shaft assembly (F). Account for three
flat washers.
GZ276
6. Remove two cap screws securing the oil pump in
the crankcase and remove the oil pump.
GZ305
7. Remove the driveshaft (G); then remove the coun-
tershaft assembly (with shift forks) (H). Account
for two flat washers on the countershaft.
GZ280B
8. Remove the reverse idler gear (I), shaft bushing,
and two washers.
GZ279
NOTE: Do not disassemble the countershaft
assembly unless necessary. If necessary, see Ser-
vicing Center Crankcase Components sub-sec-
tion.
Next
Back
Section
Table of Contents
Manual
Table of Contents
