2-8
CF105A
2. Using a suitable brush, clean the carbon deposits
from the screen taking care not to damage the
screen.
NOTE: If the screen or gasket is damaged in any
way, it must be replaced.
3. Install the spark arrester assembly with gasket;
then secure with the three cap screws. Tighten to
48 in.-lb.
CF104
Engine/Transmission
Oil - Filter - Strainer
OIL - FILTER
The engine should always be warm when the oil is
changed so the oil will drain easily and completely.
1. Park the ATV on level ground.
2. Remove the oil level stick/filler plug.
CF109M
GZ415A
3. Remove the drain plug from the bottom of the
engine and drain the oil into a drain pan.
733-441A
4. Remove the oil filter plug from the filter mounting
boss (located on the front side of the transmission
case) and allow the filter to drain completely.
Install the plug and tighten securely.
5. Using the adjustable Oil Filter Wrench and a suit-
able wrench, remove the old oil filter.
NOTE: Clean up any excess oil after removing
the filter.
6. Apply oil to a new filter O-ring and check to make
sure it is positioned correctly; then install the new
oil filter. Tighten securely.
NOTE: Install a new O-ring each time the filter is
replaced.
400/H1
H2
Next
Back
Section
Table of Contents
Manual
Table of Contents
