3-94
GZ103B
10. Remove the E-clips securing the shift linkage to
the shift lever and shift shaft; then remove the shift
linkage. Account for two bushings and two flat
washers.
11. Remove the cap screws securing the rear drive-
shaft yoke flange to the rear output flange.
GZ374
12. Remove the exhaust pipe springs at the muffler
and remove the muffler. Account for the grafoil
seal.
GZ372
13. Remove the nuts securing the rear exhaust pipe to
the cylinder; then remove the springs securing the
rear exhaust pipe to the front exhaust pipe and
remove the rear exhaust pipe. Account for a grafoil
seal on the pipe juncture and a seal in the cylinder.
GZ099A
14. Remove the front and rear spark plug wires from
the spark plugs; then disconnect the primary wire
connectors from the coils and remove the coils
from the left side of the frame.
GZ071A
15. Remove the cap screw securing the engine and
harness grounds to the engine.
GZ064A
16. Remove the cap screws securing the upper bumper
support to the frame and swing the bumper for-
ward allowing access to the radiator drain plug.
Next
Back
Section
Table of Contents
Manual
Table of Contents
