4-10
GZ383A
6. Use tape to cover and seal the intake opening.
INSTALLING (H1)
1. Install the throttle body into the intake pipe and
secure with the clamp. Tighten securely.
2. Place a new O-ring in the intake pipe; then posi-
tion the pipe onto the engine and secure with two
cap screws.
3. Connect the throttle cable to the throttle body and
adjust throttle free-play (see Section 2); then con-
nect the gasline hose.
4. Connect the four electrical connectors to the throt-
tle body components.
5. Install the air filter housing boot and secure with the
clamp; then install the air filter, air filter cover, stor-
age compartment, and storage compartment cover.
6. Connect the battery (positive cable first); then
install the seat making sure it locks securely in
place.
INSTALLING (H2)
1. Connect the throttle cable to the throttle body; then
remove the tape from the intake manifold and
install the throttle body using a new O-ring.
Tighten the cap screws securely.
GZ381A
2. Connect the three wiring connectors to the sen-
sors; then install the air filter housing and connect
all hoses. Tighten all clamps securely.
GZ094B
GZ091A
3. Connect the wiring connector to the IAT sensor.
4. Install the front rack and body panel (see Section 8).
5. Install the seat making sure it locks securely in
place.
Throttle Cable Free-Play
To adjust the throttle cable free-play, follow this proce-
dure.
1. Slide the rubber boot away; then loosen the jam
nut from the throttle cable adjuster.
AL611D
CAUTION
Any objects or liquid entering the intake opening will
fall into the engine causing severe damage if the
engine is turned over or started.
Next
Back
Section
Table of Contents
Manual
Table of Contents
