3-143
3
GZ345B
4. Carefully join the crankcase halves by placing the
left-side crankcase onto the assembled right side.
Secure with the cap screws (eight left side and one
right side).
GZ342
5. Tighten the cap screws to 8 ft-lb using the pattern
shown and turning the shafts frequently to ensure
there is no binding.
NOTE: Rotate the shafts back and forth to ensure
no binding or sticking occurs.
GZ375A
NOTE: Cap screw number eight (8) is installed
from the right side.
NOTE: If the secondary drive/driven assemblies
have been disassembled, refer to Servicing Center
Crankcase Components for proper gear tooth con-
tact and backlash.
6. Install the locating ring in the crankcase assembly;
then install the secondary driven shaft assembly
and secondary drive assembly making sure the
locating ring and bearing engage correctly.
GZ269A
GZ322B
7. Make sure the locating pins on the front and rear
bearings are correctly seated in the crankcase.
8. Install two locating pins into the upper crankcase
assembly; then apply a thin bead of silicone seal-
ant to the lower crankcase cover.
GZ322A
Next
Back
Section
Table of Contents
Manual
Table of Contents
