3-53
3
CC001D
NOTE: Keep the mounting hardware with the cov-
ers for assembly purposes or thread them back
into the head to keep them separated.
2. Remove the 12 cap screws securing the valve
cover to the head; account for the four rubber
washers on the top side cap screws. Remove the
valve cover. Account for and note the orientation
of the cylinder head plug. Note the location of two
alignment pins.
CD205
CD206
CD211A
3. Loosen the cap screw on the end of the tensioner;
then remove the two cap screws securing the ten-
sioner adjuster assembly and remove the assembly.
Account for a gasket.
CC009D
4. Using an awl, rotate the C-ring in its groove until
it is out of the cylinder head; then remove the
C-ring.
NOTE: Care should be taken not to drop the
C-ring down into the crankcase.
CC012D
5. Bend the washer tabs down and remove the two
cap screws securing the sprocket to the camshaft;
then drop the sprocket off the camshaft.
Next
Back
Section
Table of Contents
Manual
Table of Contents