3-25
3
29. Adjust valve/tappet clearance (see Section 2).
30. Place the two tappet covers with O-rings into posi-
tion; then install and tighten the cap screws
securely.
MD1264
31. Install the spark plug and tighten securely; then
install the timing inspection plug.
Left-Side Components
NOTE: For efficiency, it is preferable to remove
and disassemble only those components which
need to be addressed and to service only those
components. The technician should use discretion
and sound judgment.
NOTE: The engine/transmission does not have to
be removed from the frame for this procedure.
Removing Left-Side
Components
A. Cover/Stator Assembly
1. Remove the cap screws securing the outer mag-
neto cover and remove the cover.
2. Remove the left-side cover-to-crankcase mounting
cap screws noting the location of the 8 mm cap
screw with the washer near the middle of the
left-side cover. Keep the different-lengthed 6 mm
cap screws in order for installing purposes.
MD1186
3. Using an appropriate side case puller and the 6
mm adapter, remove the left-side cover w/stator
assembly. Account for the two alignment pins and
the position of the shifter bracket for installing
purposes.
CC946
MD1188
NOTE: Inspect the inside of the left-side cover for
any shaft washers that may have come off with the
cover. Make sure they are returned to their respec-
tive shafts and that the starter idler gear spacer is
on the shaft or in the cover.
B. Rotor/Flywheel
C. Starter Motor
NOTE: Steps 1-3 in the preceding sub-section
must precede this procedure.
4. Remove the rotor/flywheel nut.
AT THIS POINT
To service any one specific component, only limited
disassembly of components may be necessary. Note
the AT THIS POINT information in each sub-section.
Next
Back
Section
Table of Contents
Manual
Table of Contents
