3-70
CD939A
CD940A
11. Remove the two starter gears from the crankcase
noting the direction of the beveled side of the
gears for installing purposes; then remove the two
starter gear shafts.
CD136
CD140
12. Remove the snap ring securing the water pump
drive gear; then remove the gear noting the direc-
tion of the sides of the gear for installing purposes.
Account for the drive gear alignment pin.
CD944
13. Remove the snap ring securing the water pump
driven gear; then remove the gear noting the direc-
tion of the sides of the gear for installing purposes.
Account for the driven gear alignment pin.
CD952A
NOTE: There is an oil passage beneath the driven
gear/drive gear assembly. This passage should be
plugged prior to removing the driven gear and
drive gear. Failure to do so could result in the loss
of an alignment pin into the crankcase.
14. Remove the shift shaft noting the timing marks for
assembling purposes. Account for two washers.
PR430A
AT THIS POINT
To service the magneto assembly, see Section 5.
Next
Back
Section
Table of Contents
Manual
Table of Contents
